PulseGuard Pulsation Dampeners

Fluid Flow Control Animations
PulseGuard Pulsation Dampeners
Contact PulseGuard
 

Hose / Tube Pump Pulsation Dampener Installations

How to ensure lowest in place cost and most performance by standard installation methods. Halving the cost and tripling the performance, of staying "pulse free" in hose pump systems. DAMPING SUCTION SPIKE & DISCHARGE "BACK-FLOW" ON HOSE PUMPS.


Hose Pump


Pulsation Dampener site - arrow Click Here for pulsation dampeners for hose pumps listed by dimensions and connection size

elastomer and clear flow pulsation dampenerselastomer and direction change pulsation dampenerselastomer T off line plastic pulsation dampeners
elastomer lined Td off line pulsation dampenersflexflon ptfe and flow through pulsation dampeners


Flow fluctuation is caused by: When the shoe hits hose, liquid goes backward up suction pipe. When shoe lifts off, liquid rushes back to fill the void in the hose. The pipe turns the flow spikes into pressure spikes.

The flow rate can not increase or decrease momentarily because the speed of rotation is constant. So the
blip from the shoe or wheel mashing the hose, has to result in "back flow".
Discharge pulsation dampener with PermaCushion foam and ClearFlow FlexTube. No air charge required.
Normally the suction supply system is fitted with an identical PumpGuard, but here the tank is less than 20 pipe internal diameters from the pump inlet.
Chosen where ease of flush through in place cleaning is enhanced by using DuPont Teflon or LDi “FlexFlon”. And where the compatibility of PTFE diaphragms will increase life. FlexOrber LP is an off the shelf inventory dampener in the two connection standard form. If you only wish to use one connection, save a “T” and use the other for system drain, etc. Chosen where you want an elastomer compatibility, plus in place flush through. Flow through is standard; a single connection is special because even if you do not wish to use flow through, you can save a “T” for your RV or drain by using the second connection. PipeHugger LP is an off the shelf inventory item with two connections.
 PipeGuard with the addition of a single flange is available as a special at extra cost and lead time.Single connection PipeGuard flow fluctuations dampeners are applicable where a 60% fall in pressure pulsation damping ability is not a concern. Stainless PipeGuard's are less expensive than plastic pressure vessels and safer in the cold. You can always oversize the dampener to compensate for the pulse going straight past. Lined with the same elastomer as the bladder is a cost saver where plastic would be dangerous and the compatible metal is expensive. Only one small insert of special material such as Tantalum, Zirconium, etc. is necessary.The flange face on the end of PeG-LND is also provided with an FNPT thread.

PulseGuard Pulsation Dampeners
Dampeners that do, flow goes through but pressure pulsation does not.

PulseGuard pulsation dampeners are designed to address pressure pulsation, which is caused by the resistance of the system to flow. Therefore our dampeners focus on the system related responsibility and are less related to pump liability.

 



Fluid Flow Control Pulsation Dampeners