PulseGuard Pulsation Dampeners

Fluid Flow Control Animations
PulseGuard Pulsation Dampeners
Contact PulseGuard
 

PulseGuard Pulsation Dampeners PDF PDF PG155 VIEWSHEET Printable Version

Flexorber Polished Stainless Wetted Parts Pulsation Dampener Dimensional Drawing

MATERIALS AND VOLUMES for DAMPENERS
Pulsation Dampeners with PTFE / Teflon / Flexflon Diaphragms from PulseGuard are available in the "FLEXORBER LP" range. They are constructed from "hydro formed" dishings, from 316/316L. and other corrosion resistant metals. The PulseGuard FlexOrber LP range of dampeners has volumes from 10 cubic inches (0.15 Liter) up to 1000 in3 (16+ Liters).

STANDARD PRESSURE RATINGS for DAMPENERS
Flexorber Pulsation Dampeners from PulseGuard have part number designators "SOG", this covers pressures from 150 psi which are known as VLP (very low pressure) series, up to 1250 psi . Above that pressure PulseGuard pulsation Dampeners with PTFE and similar membrane diaphragms are offered as the "FLEXORBER HP" range. These dampeners are machined from solid billet. HP dampeners have a designator "FLO" and have secondary containment and double layer membranes with hazard alerts.

AVAILABLE OPTIONS for PTFE membrane DAMPENERS
The SOG dampener view sheet shows the "food and Drug" optional trim with stainless support rings pt. nbrs. 5 and 5a, plus polished liquid contact parts item 3.
Membranes:
The diaphragms of the dampeners are in 2 forms. To the left of the center line the DW FLEXFLON series membrane is shown with bolted ant extrusion method, parts 8a 8b. To right of center the dampeners have diaphragms without bolt on anti extrusion plates, they are encapsulated within an elastomeric backing to a virgin PTFE smooth faced diaphragm pt. nbr. DF---TFE-EP. This is the most cleanable version. Click here to goto heating / cooling jacketed option

SERVICEABILITY
All flexorber dampeners are available with item 7 quick release minimum down time piping base blocks . The dampener shown here has polished food industry quick clamp connections 7a 7b.

The dampener capsules can be replaced with "By-Pass / Diverter Block" shown top right. This enables the pipe system to be hydro testes or flushed and sterilized while the capsule dampeners are being serviced, pre-filled, or bath sterilized.

CONNECTIBILITY
Dampener piping base blocks are used as the confluence of many flow streams, there may be up to 5 flow streams, see bottom left. This enables pressure activity to be intercepted and resonance prevented. The connection to connection dimension is normally similar to the OD of the Dampeners.

These PulseGuard Pulsation Dampeners View Sheets, are erroneously called dimensional "drawings" which means to scale, which these views are not. A drawing is to scale and shows detail, a sketch is to scale and shows less detail, dimensional drawings are not drawings, they are non scale views. PulseGuard pulsation dampeners are shown as "view sheets" or cross sectional "cut sheets".

 

PulseGuard Pulsation Dampeners
Phone: 910-270-2737 • Toll Free: 1-888-DAMPERS (326-7377) • Fax: 910-270-2739
295 Sloop Point Loop Road, Hampstead NC, 28443 USA • Contact Us



Fluid Flow Control Pulsation Dampeners