PulseGuard Pulsation Dampeners

Fluid Flow Control Animations
PulseGuard Pulsation Dampeners
Contact PulseGuard
 

WaveGuard HP No Moving Parts Pulsation Dampener Maintenance

SERVICE, DISASSEMBLY AND RE-ASSEMBLY


Part Number and identification: Dampener Type / Wave dispersal ball material / equivalent to N2 compressibility in3 / Design Pressure / WaG / Cer (ceramic) / psi or Br

STRUT VALVE OPENED & CLOSED WITH 3/4" WRENCH.
The STRUT valve enables you to SAFELY STOP nitrogen pressure entering a dampener .

On the other hand these 3 valves all have pin cores in them.

Not only are the pin type valves dangerous, but also you have to spend 500 on a regulator and 250 on a pre-fill tool, to use them.
Connections / Wetted Metal - Flange / 316, A20, HC276 etc. For frequencies above 100Hz in clean liquid systems. Elastomer lined Do not reflect the pulsation before we can address it use “5D” bends – no elbows “O” Ring face seal Lock Ring groove “O” Ring diametral seal Impervious ceramic balls “O” Ring face seal - 3 segment lock rings from groove - Carbon steel boltings prevent galling in stainless steel thread When installed vertically, self draining, there is generally no maintenance required. Available spares are

 



Fluid Flow Control Pulsation Dampeners